build your own shed ramp

How to make a ramp for your shed

Measure the height from the ground to the shed floor.( make sure your door or doors when shut aren’t lower than the floor if they are measure the bottom of door or doors to ground)
Measure the opening width of the shed.
Depending on the height you will need either 3) 2x6’s or 3) 2x8s pressure treated
1 sheet of ¾ plywood
Now cut the 2x’s approx. 5’
Now mark the side of the 2x’s with a straight line or calk line to the other side
Now cut along that line you should have a wedge
Now cut 4x8 plywood 5’ and width of opening of shed
Put the cut 2x’s on flat level surface ( inside shed)
Lay the cut plywood on top of 2x’s .one in middle two on sides. Screw in.
You may want to flip over and brace with other 2x’s
Put up against shed. Now you have a easy way in and of your shed